Recent content by Super7

Just bought this 3 months ago and wound up not using it. PayPal only. Ships to Lower 48 only. Thanks

Here you go.

Done

It does not to be repaired. As for the chamber, it’s for a Dasa 1100–mod I’m assuming.

Thank you.

Excuse my ignorance but I don’t see a PM…

Used 1 summer. Rub mark from exhaust—pictured. As for the foam pad that sits beneath it and also cradles the battery, you may need to add or subtract foam to make it sit flat. Can accept a credit card or PayPal with buyer paying all fees. Ships out of Portland. Thanks

Used for 1 summer. Has wear from rubbing the hull—pictured. Comes with all hardware. Can accept a credit card or PayPay—buyer pays fees. Ships by UPS out of Portland, OR. Thanks

This has less than 30 min. run time and I guarantee its near perfection. I paid $1950.00 for it through Blowsion. Buyer pays shipping and fees. I can accept a credit card or PayPal. Ships UPS out of Portland. Thanks

Off market. m picking up a new Edge so this one will go. It’s in Portland and also listed on FB-more pictures there. I‘m keeping my motor/carbs/electronics and would like to sell what’s remaining in one transaction. Power Factor laydown pipe and waterbox—1 summer of use. Blowsion fuel tank—1...

Decoded to keep.

Like new—less than 1 hour. Buyback guarantee. Attached is a receipt. As I’m no parts expert, the crank was sold new to me by Blowsion as a DASA crank but I don’t know how they are identified. I see that the rods are Hot Rods with no other identifying marks other than 78 etched into it. I paid...

Decided to keep.

This was tested for less than 30 minutes and removed. As-new condition and I believe I paid somewhere around $475.00 for it. I have no use for it. I guarantee its condition. PayPal for paymen. Buyer pays fees and $15.00 shipping within the Lower 48. Thanks—-Rod

So I’ve got one season on my Dasa 1100 (10 mm stroker). Its got a Yamaha stator that I installed without advancing the timing and my question is how much difference in performance is gained by advancing the timing and how much is safe? I’ve heard 5 degrees or about the width of a nickel is what...