Recent content by Strangfactory

Second day out riding! Sent from my XT1030 using Tapatalk

Well its glasses in... Sent from my XT1030 using Tapatalk

Little up date. I went and picked up some parts from Blowsion. I got this and my cold fusion internal fuel fill, worx intake grate and new hood seal. I got most the pull bracket area and fuel fill area sanded. Question, would puting two layers of 1208 over the old fuel filler hole be enough or...

Sent from my XT1030 using Tapatalk

So on the crack that goes under the hood seal, how should I go about fixing it? Sent from my XT1030 using Tapatalk

I will take your advice :) thanks for pointing out the mods page. I'll definatly check it out! Sent from my XT1030 using Tapatalk

Okay, thanks. Sent from my XT1030 using Tapatalk

Newb question that I could quite find the answer two. She. Doing two layers of 1208 bixial glass do I need to let the first layer dry first then sand or can I get the first layer on and wet and add the second? Sent from my XT1030 using Tapatalk

Thank you guys Sent from my XT1030 using Tapatalk

So do I need to use twill? Also do I add cabosal to the epoxy when laying the fiber glass or is that just for filling areas? Sent from my XT1030 using Tapatalk

Do you guys know what's the best temperature range for epoxy to setup? Sent from my XT1030 using Tapatalk

Haha, I thought I read somewhere that SN didn't have it. Thanks Tomski. Sent from my XT1030 using Tapatalk

Gel coat is only on the bottom side of the hull? Sent from my XT1030 using Tapatalk

Thank you. Sent from my XT1030 using Tapatalk

Okay, would it be more beneficial to use Kevlar or carbon fiber? Carbon fiber is probably not sandable for a good out side finish? Sent from my XT1030 using Tapatalk