smd's latest activity

  • S
    smd replied to the thread Sxr 849 tuning.
    Turns out my low speed screws had the wrong o-rings which screwed up my tuning. I went back to the Group K jets and setting...
  • S
    smd replied to the thread Sxr 849 tuning.
    That is a simple and accurate tuning method. A much easier read than Harry's too! Lol.
  • S
    smd replied to the thread SXR 800 Carb and Manifold.
    If someone has the 40-I's or a single Mikuni 46 SBN I'm still interested. Otherwise I'll just look for another 40-I's intake manifold...
  • S
    smd replied to the thread Sxr 849 tuning.
    Group K has two pretty thorough write ups on carb tuning. I'd start there. Also did you do a leak down test on your motor. If it isn't...
  • S
    smd replied to the thread Sxr 849 tuning.
    I have the same setup and are going through the carb tuning thing to. Group K sends them out with stock jetting L=72.5 H=132.5. They use...
  • S
    smd posted the thread SXR 800 Carb and Manifold in Want To Buy.
    I'm building a spare backup SXR 800 motor. I have everything but the carbs and manifold. For a backup I'd like something nice, but...
  • S
    Lol. No it's for when you have an explosion in your engine compartment like I had!
  • S
    I had technical difficulties once (well more than once) with a Kawi 550 and I was glad it had a blowout plate and that it was chained to...
  • S
    smd replied to the thread SXR Head Cooling Barb Tap Size.
    People may or may not appreciate this level of detail. The Kawasaki's use the JIS (Japaneses) standard threads which are...
  • S
    The 650 had room under the hood over the engine. That basket is pretty deep. I doubt it would fit a SXR. Plus you have to drill a bunch...
  • S
    smd replied to the thread SXR Head Cooling Barb Tap Size.
    Yes 1/8 NPT not 1/4 NPT would be the closest. I'm still pretty sure the stock fittings are something else very close to the 1/8 NPT. I...
  • S
    These guys made one for a 650SX way back when. I got one, but bought a 750SXI before I got around to installing it. Kawasaki Jet Ski SX...
    • DSC01427.JPG
  • S
    smd posted the thread SXR Head Cooling Barb Tap Size in SXR.
    I need an extra cooling line tapped into a 750 head for an SXR. I think it's a JIS / BSTP 1/4-19, but can't find it for sure anywhere...
Top Bottom