Recent content by sj650bp

Thanks, I was just hoping there might be an answer such as put the same size jets in as the SJ shows and set the high and low speed the same, but it appears with the different port timing for the 62T and the different f/a's that would not be possible. I still might put stock f/a's on and then...

So do you think the F/A's will make up for the richness? I looked up the difference in the jets. It shows that the WV has a 120 main jet in #1 carb and 130 in #2. The superjet shows 130 for both. The WV shows 67.5 on the pilot jet and the SJ shows 70. Everything else is the same except for...

Thanks for the suggestions. I noticed on the horsepower rating for the Waveventure vs. the SJ and it rated the Waveventure higher so the only thing I could assume is like piratelife said that the pipe works better on the venture. I guess what I could do is check what jets are in a stock SJ and...

Any suggestions on jetting? I know I am a little worried about taking water in with them. I am not much of a carb guy so any suggestion would be appreciated. I can tear 'em down and clean them, replace parts etc. Thanks

I put a 62T out of a WaveVenture in my 93SJ. What my question is I put a RIVA non-girdled head with gas domes on it with a set of WestCoast Velocity Stacks. The motor has been bored to 82.5mm. Will I need to do any rejetting on this? I am running a stock 701 superjet exhaust. Attached is a...

Thanks for the all the answers...got to love this forum...

Putting a Riva non girdled head on my 701. The spark plug holes are much deeper than the stock head. What plugs are recommended for this head? Do I just get the ES plugs? Thanks....

Was wondering if you had a chance to figure out if you could do a set of graphics for me? The last we talked I think you were going to check on the amount of vinyl you used. Thanks