Recent content by RookieOTY

Damn never saw this I built a v3x now

So I picked up a 5mill stroker 62t cases with 61x top end, I have a set of dual 44s with pro tec intake I have v2 reeds with a spacer plate also plan to run hot products flame arrestors anyone got any advice on jetting and pop off? Any tips help! Thanks

Water craft factory hood and sponsons

I’ll take the hood latch and flywheel cover if still available

Fixed steer has a rear rocker watercraft factory hood it’s re enforced fresh paint and turf built this winter and rode at Daytona it was a blast but getting a v3x looking to get 4000 for hull/hood Orange RN has rocker kit and -3 or 4 in the rear needs to be re enforced has a chip in side from...

Did you bring it tona?

What about electronics?

Yes just had to play with the high/ low screws tuning is definitely tough just takes patience and long day at the landing I just built another ski and took me 2 trips to lake to get it dialed in helps to have a tac on the ski for sure

You got any interest in a partial trade? I have a full thrust trim setup for 144

So ik there is a washer that is supposed to go on flywheel cover at end of bendix anyone have a picture or know how it goes I lost that washer and been 6 months since I touched this project can rember how it goes exactly also do these o rings go on the bendix?? Next question is how do I wire my...

Thanks, I saw that after I posted definitely helped

so finally getting around to finishing my x2 build just painted ski over weekend now to get my motor together and find all my scattered parts! Looking for any advice on putting this motor together and figured I’d share my build do have a few questions Anyone know torque specs? how do crank...

Where ya at in Michigan

Can you send me some more pics you can dm or txt 2695696689

Got more pics?