Recent content by Rexbucman

I've got the right length by using a 550 coupler on my SX shaft. The problem I'm having is the shafts don't align up and down. The pic is of my engine pulled forward still sitting on the mounts

In the process of taking everything from my 92 750sx and putting it in a 98 sxi pro hull. Having some major alignment issues with my shaft and engine coupler. The shaft pitches way up. Using the sx bulkhead bearing with the spacer that was on the sxi pro. Tried shimming the rear of the pump 1/8"...

Putting the 550 coupler on my sx shaft Top:sx Bottom: 550

I've got my sx shaft and a 550 coupler(which I'm told will make up the needed length).

3

1

1

Taking everything from my 92 750sx and putting it in an sxi pro hull. Was told that using a 550coupler with the sx pump shaft will work. Can I still use my sx bulkhead bearing?