Recent content by Red Raider 13

Ok folks, got it figured out. The ski is running like a top. It was the CDI. Also the carb was cleaned out and adjusted, The low side was adjusted to 1 3/4 turns and the high side to 2 turns. Ran as good as it ever has. I have seen where people have posted in the past that no one evers posts...

Ok, my "no spark" problem was the CDI. Still waiting for my waterbox so I can put it on the water for a real test.

r6487... I did ohm and check the volts on the stator. Mine is ok. The old ignite coil was thrown away and did not get achance to ohm it. When I first installed the ignite coil and cdi, it started right up and sounded good but after aliitle bit of trying it out, it seems to bog down when giving...

Pistolgripump.... I had no spark from the plugs. I replaced the ignition coil(since it was already thrown out) and the cdi. I now have spark. Still think I might have a little bit of carbureator issue though.

On my 91 650 superjet, I traced down and think my troubles are with the CDI and ignition coil. My part numbers for these pieces start out with number 6R7-00. I ordered in a used superjet CDI and ignition coil with part numbers 6M6-01. Will they work on my 91 superjet? Thanks in advance for your...

Hey let me know what you figure out on the "no spark." Working on a 90 model with the same issue. I just got in a used cdi and ignition coil and will try to install this week and see if that solves it. I have already checked my stator for voltage and resistance and appears to be ok with my...

Guess I don't know about the rope trick

I appreciate everyone's input.

Thanks byeai. Have located used coil and stator and should come in before long. If I have a problem, I will sure keep you in mind for your used ones.

In a couple of days or as soon as as the stator gets here , I will be replacing it. Never done it before. Any tricks to removing the flywheel and replacing the stator that I should know about on a 91 stock 650 Superjet. As far as the timing, should I make a note on where the alignment mark is...

Thanks again. Have already tried disconnecting the kill switch wires.

Hello, new here but working on son's 91 Yama 650 Superjet. He started having problems with it not feeling like it was powering up all the way. Then, it started bogging down when it was given full throttle. Next it would not start and after letting it sit for a while, it would start but not much...