Recent content by Old standup rider

I have a rebuilt 701, new old stock cases from Riva. I think I bought the cases in 08 The crank is used with about 100-125hrs all bearings and rods are in great shape. Cylinder is from a 2010SJ honed and still at 81mm. Pistons are new and have a coating on them. Head is a 61x was hot tanked and...

ordered

Much appreciated

Ha, thought you mentioned member Watcon

He hasn’t been active since 2011

Looking at switching out my AC pole and I’m needing a round nose to square pole bracket. Thanks in advance

Looking for a D cut ride plate or any other freestyle for a Square Nose. Not interested in a stock D cut. I currently have Wamiltons that’s running a little thin from all the years of use. Just seeing what I can find before ordering a new Blowsion D cut. Thanks in advance.

Looking for a decent set of jugs for a 1100 63m motor. I will be boring them to 83mm so they don’t have to be mint! Thanks

Your telling me, piston is trashed! Luckily the cylinder didn’t get hurt. I think I forgot to put oil in that cylinder before firing it up. Dry cylinders and new rings are a bad combo

Found the issue, rear cylinder rings were stuck! I was only getting 30psi

Cylinders were scored, compression was 105, 114 & 96. I had some 83mm on the shelf, it ran pretty much the same before. I was hoping the new bore and pistons would help. I’m leaning more towards carbs, only because I don’t have any runaway/ dieseling

My motor has an issue, like it’s starving for fuel, idling rough almost like a car with a cam in it. It’s pretty much a stock 1100 only thing done is a complete top end rebuild with 83mm wiseco pistons all new gaskets and fuel pump. Carbs were not rebuild and crank seals not replaced! The motor...

Thanks guys, they are Ada domes. I finally got a hold of blowsion also and they confirmed The domes are not interchangeable

Ya, it an old head

Dumb question maybe, but do blowsion domes fit ADA heads? I have 33cc domes but want 37cc