Recent content by Mr Bojangles

Stuff I am bringing to the freeride for sale. SBT top end parts for a 701 $80 PFRacing pole, chin pad, pole mount, xmetal turn plate, blaster riser bars $180 I'll be there Friday to Sunday, shoot me a Pm if interested

I havent made any of these in awhile, but I do have the original blanks and molds if you want them, they are yours if you want to come down and pick them up

Yup, and this one too...... https://instagram.com/p/5Lb8NSHvti/ I like mine :) otherwise I wouldn't have picked it

Worked on the trailer today and got my pole and controls situated. Came up with a pin setup for my freak that I hope will hold up. I still will use straps and tie downs, pin is just for the boat ramp to get it on quick

I had the choice and I really didn't like the new graphics, this one reminds me of a plaid pattern and I dig it

It's the raw glass, it was turfed to the edge and cut flush. I need to paint it

Motor is in, pump and thrust trim is in, almost time to ride

On the Titan the ebox will hit the b pipe and I already had the ebox mount drilled, so I made a offset braket to move the box over and use the holes already in the tray. I also got all the hull fittings in, problem is the hull is thick!!!! Not much play for the bilge and pissers.

All mounts are in, ready for the motor!!!

Well the day is saved! I tried to heat the bolt and use vice grips and only made it worse. My buddy Jason tig welded a nut to the remaining bolt and we managed to get the bolt off.

I looked up the specs for the stuff and it said it was good up too 1400° but the dissimilar metals may have played a big roll with corrosion. They do make different compounds with copper, aluminum and so on though

Well pulled my protec exhaust off and after 4 years 3 bolt heads snapped off! So pissed and I used anti-seize too!

I sure hope so, I had a older x metal setup and the bearings never lasted so I went to Teflon DIY bearings I made. I am running risers on mine, so I hope I don't have to chop up the carbon chin pad too much

Thanks Kohl Tonight was slow, the RRP fat bar setup would not bolt right up to the X Metal pole mount. The OD was 1.0 of the RRP and the X metal was 0.9 and then the stop pole had to be milled down .1 as well to match and not rub

I haven't seen enough Titan threads or pics so hopefully this will help anyone out with one or wanting one. I am upgrading from a old WCF hull owned by Lucas and I chopped -2 off the rear and widen the rails and loved it, but it was time to move on. I rode Jetmaniac's Freak and Yamasluts freak...