Recent content by motorman021

I am selling my 96 750 sxi clean pink and the ski runs great its got wamilton filters and the carbs were rejetted to match its also got wcf footholds in it, an ocean pro ride plate, rear sponsons, short steering plate, umi bars, billet throttle, odi grips, and primer conversion, I need to sell...

98 sxi pro you were exactly right i went to the hardware store and bought the green can bcz it said non flammable i figured who knos mayb it will make a difference i tried using it and it wouldnt stick for :-):-):-):-) it reminded me alot like elmers wood glue so today i went and switched cans...

i am in the process of installing my hydro turf i brushed the contact cement on one side of the turf and on the ski were its goin i let it sit for a 10 mins tell it got kinda tacky and wen to install it and it wouldnt stick so i tried to brush it on and then stick it and it wont hold to the side...

can you swap the motor plate to an sxi pro from what i hear the pro's have the motor set further foward?

how quik did the turf fade i literally ordered lime green turf yesterday

i jus put foot holds in my ski and alotta ppl told me to do the 2 part foam but i couldnt find it locally so i talked to some ppl and they said foam in a can will work i filled the sides up with the spray foam and it dried perfectly fine i just used the great stuff foam for holes bigger than 1 inch

unhook all the wires and cables from the bars the start stop button throttle etc remove the four bolts from the pole mount they will be in the hull right above the gas tank then pick up the bracket high enough to get to the bolt i believe it was a 19 take the nut off then take the bolt out once...

wen you mean cut/chip them out you mean on the very back of the ski kinda like just pull the tubes out the back? jus started on the install tonight and im having a hell of a time getting the tube out

ok wat did you do about your compartments did u remove the compartments completely or did you just glass over them right were they were at? do you need to epoxy them in place or can you just rivet them and glass em in?

Hey i got a 750 sxi and im gunna install my foot holds does anyone have any mesurements as to how far back to put them?

I ordered some footholds for my sxi and was wondering what ppl are doing with there fire extinguser compartment and tool compartment i know you have to cut them out the fit the foot holds but do i just leave the end caps there or am i supposed to fiberglass them shut?

i wanna get my sxi set up for the surf im in grover beach about 2 mins from the dunes but i dont wanna :-):-):-) my ski up either

once i have the money i will get tubbies i wanna get the new turf so i can ride it again then the exteneded ride plate then tubbies

i ordered the wcf footholds and they say you dont have to move the exhaust

ya its sketchy but i will still prob do it again the next time i get out ya i noticed the lighter smaller ppl plane way easier im 260ish and 6'4" so im screwed all the way around but im sure ill get the hang of it mayb if i shorten the pole a few inches..... sxi steve it says custom pole did...