Recent content by mitoevo

Is it possible to mix up a ported factory b pipe manifold with a non ported factory b pipe head pipe. I know its not the best combo but at the moment the only thing I have. Dont want to port the headpipe beacause I will use it later again. So the question is can I use this mix or do I get a lot...

Hello I know the „perfect“ squish is between 0.040-0.045“ My cylinder was grinded and know I need a new base gasket. i am thinking about to use one to get a squish of 0.05“ because I do a lot of unterwater Freestyle tricks and it can be that there comes some water in into the Engine. I know...

thanks for the fast and Perfect answer

Only crimp the wire or with the thin wires that are drilled around the small wire

Hello Is it possible to shorten the oem spark wires? One of my spark wires was broken directly in the front. i have shortened it but the oem one looks like it was soldered on the one of the wire. is it possible to use this wire now after trimming it ?

Really nice

Nice building but I would not dismantle the pump shoe or do you replace it ?

Getting green :-)

Really nice work

Verry nice line the original graphic

Heat gun is the easiest way