Recent content by mega_loads

Hi Chris. I need a pre 08 SJ drive shaft and intermediate shaft if you have them available. Thanks Austin

I know this was ages ago. But did you ever get jetting for this 845 with dual 44s

Its not fully assembled right now. I'm going a different route at this time. I would like to sell the cylinder,head and pistons at this time

I could use a head and base gasket if you still have some RMBC. thanks also i willing to sell this setup as a short block if someone wants it. 62t case and 5mill crank with this same cylinder on top #23

Sweet they are great learner skis for kids. I'm helping a buddy out doing the same for his boy.

Thanks for all the info. Its saves so much time to have a starting point. Thanks again sliverbullet

Looking for some jetting on 38 sbn on a stock 300sx. Any good starting points would help. Thanks Engine is stock

silverbullet what did you end up jetting the sbn 38 at because im doing the same. thanks

I rebuilt this one a couple years ago it was a blast..

I need some jetting help I have a 62t/61x 81.5 bore 5mm stroker running dual 44 and I just can't get the power it should have. the jetting now is 95 L 1 1/2 out 125 H 1 1/2 out it is slow sluggish out of the hole the power is not there. any help would be a big help. thanks

anyone have a similar set up? im just looking to get in the ball park.

i just put together a 62T/61x 5mm stroker bore is 81.5 compression is 180 im having issue with jetting. I m running dual 44 protecs stock ing also fp with tnt chamber and heavliy ported cylinder and cases does anyone have a good idea of where to start ? any help would be awesome. thanks

what would you charge for a hood?