Recent content by MB465

I would start off by getting a Oem carb rebuild kit and drain the fuel and get a clean slate.

assuming it ran before the bendix was changed?

Sounds like it’s advanced on the timing but are you getting a ton of pressure out of the carb when it backfires? Sent from my iPhone using Tapatalk

Hopefully it wasn’t yours but I did hear about one being crushed from the highway patrol out here for the vin tag being relocated about 4 years ago. Sent from my iPhone using Tapatalk

not sure if that cold fusion drive line tool works on a square nose bulk head.

By fuel water separator I mean the air intake on the line that has the check valve Sent from my iPhone using Tapatalk

Have you drained the tank could be water in the tank then it’s mixing with the fuel after a few minutes of riding. Have you drained the fuel water separator? Sent from my iPhone using Tapatalk

You can get one at local dealerships they just have to have a sister store out of state and they transfer the title as “used” between dealers.

worked out pretty good doing it, I guess only time will tell if I have the eye of a pigs ass. mine looked fairly similar to that when all was said and done though. Added two 150 thousandths shims before I even got to start on the alignment due to that reduction nozzle.

I recently bought a sn hull that has the dowel pins removed from hull to align the pump and has a protec trim/nozzle on it. The bolt mounts for the nozzle are a good half inch off of the hull when the front bolts are tight. Is there a better way how to align the pump then just micing it around...

Ok then it’s a 701 chamber Sent from my iPhone using Tapatalk

Post a pic of the chamber Sent from my iPhone using Tapatalk

do you know if the chamber is a 650 or 701 chamber? did you pull it off of your 650 or a new pipe?

Efi like electronic fuel injection? I’m confused about the filters

http://www.mikuni.com/pdf/sbn_manual.pdf This helped me understand mine more pg 15 is the pop off chart. Sent from my iPhone using Tapatalk