Recent content by mattnz

based off WDK Rev footholds and custom front foothold

Long time since an update, its nearly the end of winter here and haven't been out riding lately and every now and then get a chance to do a few bits and pieces. After some riding on the ski found the ski was very loose and fun to ride, with the angle cut rear and short ride plate i don't even...

Yes that's correct, made the holes to suit 08+ ride plate

The ski is now 98% finished just a few little bits to finish off. Primer on hull mocking up lengths for the hood-strap ratchet system Big Thanks to big brother SI for his painting job here he is looking happy as ever... Helmet has a silver pearl, I was going to do the whole ski like...

Finally starting to get bits sorted, engine is all together went a bit more aggressive with porting the cases. hull is all painted just finished painting inside bilge/engine area. just need to polish some more bits, fab up a aluminum fuel tank, and put all the other bits together.

This build was started a while ago but thought i would upload it to the X this is where i have found lots of ideas for my build and before its finished for any other good ideas. Mid 2012: Well I thought I might as well start a build thread of my first ski, 96 Yamaha superjet. Before: Mods...

Anyone know where to find/buy a stinger fitting which take the jets?

drilling stock pump for daul cooling: http://www.dalusionfwx.co.nz/forum/viewtopic.php?t=3203

Ok cheers everyone. this explains a lot when i first was running it got blocked a couple of times as no water was coming out pissers. The pipe was second hand off someone and they didnt say anything about installing etc. so didnt really know what i was doing. But it came with no restrictor jet...

Ok sweet, Ive found the inline filters in the Hot-products catalog. This fitting should have the restrictor jet? mine is not straight like this one it just has a standard elbow

should these filters be run on all pipes? or especially just on the speedworx pipe

so the main jet is built into/attached to the pipe? So one of these could be used? http://www.performancecatalog.com/watercraft-Sand-Filter-p/rs1013-sdf-464.htm thanks heaps don't know much about the workings of this pipe

These pipes certainly do work great, i had it setup on my ski before i rebuilt it and it was a big difference compared with stock. Just was running single cooling before now im running dual just want to get the setup right. cheers for that so remove the tee and remove flow control & replace...

Hey I'm after the correct water cooling setup for these pipes, any help would be appreciated. This is what Ive got so far, The diagram is of a b-pipe i found on here and i have added the other outlet that the speedwerx pipe has (the one with red line through it) so it would run 3 pissers for...