Recent content by markmarvin30

  1. M

    Super Jet Solas Mag Pump Ate My Bearings- How About You?

    John, Would you consider assembling mine if I sent you my Solas pump, driveshaft, and bearings? I have all three things,but have never put one together. I do not have the knowledge or tools to check for the clearances. After reading for days about the same problems with the fit, I don't want...
  2. M

    Other Midshaft and Driveshaft length and fitment master list

    Are the Superjets years 2008+ 28 inches? 6BA 45511-00-00
  3. M

    Super Jet RN SJ handle pole spring

    I have a trimmed Blowsion spring on my lowered ATP bracket. The ski looks like it has a boner all the time. Limiting rope helps.
  4. M

    Super Jet you know what they say...once you go black....

    I put a big beach towel under my cover.
  5. M

    Super Jet 08+ steering

    Never been on an fx1. I assume the steering sucks on it too?
  6. M

    Super Jet 08+ steering

    So I am wondering...... Why would Yamaha put this sucky steering cable setup on the 08+ Superjets? WTF lets just make them not tun well?
  7. M

    Super Jet Shmity1 08+ Superjet steering cable install

    Do not reuse the white clip. Put it together with his c clip the way the pdf shows that I sent you. If you use the white clip and to not put the rubber plug like the drawing shows the throw/steering at the pump will be so out of alignment that you will not be able to adjust it out.
  8. M

    Super Jet Shmity1 08+ Superjet steering cable install

    I pushed mine frome the back. Also, don't screw up the order of clips ans washer in the back. The cable won't be sticking out the corrrect length.
  9. M

    Super Jet Shmity1 08+ Superjet steering cable install

    her is a pdf i got from him as a template.
  10. M

    Super Jet I need fix ideas for my pump cooling fitting.

    The fix. I bought a brass plug from Menards. I re-drilled and tapped the hole to fit the plug. I drilled out the center of the plug from the bottom then I screwed it in the hole. Took the correct sized drill bit and drilled a starter hole in the side of the plug through the outlet...
  11. M

    Super Jet I need fix ideas for my pump cooling fitting.

    If I spin the stator section, my little alignment pins will not line up. Would ther be too much torque on the 4 long bolts that go through all three sections?
  12. M

    Super Jet I need fix ideas for my pump cooling fitting.

    How do you re-tap somewhere close when the wall of the pump is so thin?
  13. M

    Super Jet I need fix ideas for my pump cooling fitting.

    So I ground the nubbin so the steering cable would not rub with my custom trim set up. So today it blew out. 10 minutes of riding for the year. 1). Cut the rectangle nub short and thread it for a brass 90 degree fitting? 2). Tap the other side for a 90 degree fitting in the cylinder...
  14. M

    2013 Torch Lake Freeride- July 13th, 2013

    sounds like a great time
Top Bottom