Recent content by Lival

Any updates

Shame it went silent.

The west pumps suck anyway. Also, make sure you have the one labeled resin and the one labeled hardener in the right can. Not trying to be insulting however, it is an easy mistake as the pump kit has 3 pumps. 2 are hardener and 1 is for resin. If you are over catalyzing the west system it has a...

I actually used a carbon bracket I created and then drilled pilot holes through the bottom of the hull and used rivets from the bottom up and then lightly sanded them and put a dab of epoxy on each. No issues there with bouncing around. Additionally I wired in a status light to let me know if...

Silly question however, just installed duals in the same location. I can remove the siphon line on the pump now right? Do I need to plug the hole on the pump housing? Planned on using the siphon tube for my trim system.

Sorry, I was never good at sharing ;)

Thanks again.. that was what I was looking for.. thanks

paul@infrafuse.com would like to see the pictures.. the more the better. thanks.

Any updates?

Kawstyler get those pics up. Many of us are interested in the internals here.

Which the hull or the pole ends?

Just noticed the sun washed out the pole pictures a bit.. damn iphone

Last of the gel coat laid down. Clean and polish the finish in the morning. Finishing the inside of the hull this evening. Started painting some of the accessories. Wrapping the pole tomorrow. B-Pipe all primed.

Top deck prior to being re-gelled last night. Time for the acetone bath! Sand and second coat today, engine bay, and wrap pole. Hopefully start the re-assembly process tomorrow.

Same. I am doing some fabrication right now for other parts and was curious about this one as well.