Recent content by john_650sx

Ship to uk? :)

200+ psi isn’t great imo

Hi guys, As above looking for a nice, clean lay down pipe please. needs shipping to uk Thanks!

Hi guys, anyone able to send me a base curve/map for the et1107 please?

As above please, consider anything, stuck screws etc or newer decent ones..... beggars can’t be choosers! cheers!!

Had this exact issue on a 1100 fixed steer SJ, it's the carbs. Strip, clean , rebuild

Hi guys and gals, Would anyone happen to have the installation/setup instructions for the Jetinetics HEAT ignition for a 701? Got the wiring diagram, but as the curve is fixed, need an idea of where to set the static timing ‍♂️‍♂️‍♂️ Any help would be great! Cheers John

Sent you email

Hi guys, anyone got a set of stock SJ hood hooks and the plate the nose cone hooks into? For 08+ SJ but think all Ran are the same?

I know how props and pumps work...it's over propped for what I want, pulls 7400rpm which is more than stock, but not close enough to the 8100 limiter. Hence, too much pitch. I'd say the 85 was SLIGHTLY better off the bottom, but the 83 was much better in general. I'll lose a bit of pitch...

So I tried the 148...even over propped the stock nozzle worked much better than the bored 85mm nozzle! Cheer guys

Aha man thats just what I wanted to hear! Appreciate it man I'll try it...

Just wonder if anyone has ran a stock 82mm nozzle on a 148 mag? I've got a 144 Solas here with the changeable pump rungs but typically it don't fit my 148 Skat pump (was gonna use the Solas nozzle to tune then have a stocker bored out to the best diameter!) So my stock raider nozzle fits...

As above please for 144/148 pump....wanting the reduction nozzle complete with trim ring and steering nozzles, bonus if it still has the 88/85mm rings in place or any other size :) Cheers

How much is shipping to UK please?