Recent content by gtlegacy

Riva online, I just got one for 5.22, 10 shipped! http://216.37.204.203//showmodel.asp?Type=13&make=kawasakipwc&A=168&B=24&vehicleid=1988-Kawasaki-PWC-X2-MUFFLER(S)

Hello All, I recently moved back to So Cal and am getting the X-2 back together!!!! I had a 750 completely built about 5-6 years ago and was running it in the X-2. The engine has a total of 22 hours on the rebuild and the ski has been sitting garaged for the past 3 years with intermittent...

ouch! that must have been some major stress. a little duck tape then lets ride next weekend! haha

cool vid mark

a good weld shop could cut out and weld in a new section for ya, shop around and you could probably get a ok deal

he seemed really good and had good spirits, its just a shame he couldnt go out with us...hopefully soon

i put a 15.5 skat in mine because of financial reasons, cant beat a free prop, and they go pretty cheap used! i have been very pleased with it, i have a 750 in mine and it has some good low end.

here is my 89 x-2 with a 750 and a coffmans pipe

just buy this! http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=002&sspagename=STRK%3AMESE%3AIT&viewitem=&item=120110449368&rd=1&rd=1

bed plates, couplers, exhaust manifolds are the same. if you go to 650 electronics you will need a 650 front cover. also make sure you take into consideration the different directions carbs pull from. i didnt realize the 750ss carb pulled from the bottom and i had to get 650sx cable to route...

i took a 92 750ss small pin 750 and had it rebuilt to factory specs with pro x pistons by RAS racing. They machined the case so the 650 electronics would work(so i could swap back in my 650). It has the stock cdk 2 40mm keihin carb and a coffmans pipe. It is all stock 750 except for the pipe and...

you wont regret doing it, i did the swap and the thing leaps out of the hole. The power is great and its reliable to!

yeah cant wait the ski ran soo good on sunday!

i met you at pjs on sat...ring a bell?

oside