Recent content by gdrum

anyone have a cheap westcoast, kerker, factory pipe worth selling? msg me or email gdrum@hotmail.com

can you help me locate longer carb bolts or suggests on where to order from? thanks

650sx parts i need the verticle trim that goes on the left and right sides for the hood i need a set of carb bolts that will clear a filter adapter on a 42mm carb..the ones i have off my 28 are too short shoot me a pm

I just read this forum and everyone almost advises to stay away or not spend a dime. I picked up a steal on an aluminum pole which I am lacking motivation to install..once that is put on then im guessing it might not end up a decent cheap ski.

Got block off plate Cleaned bottom of ski and all oil residue out. Comp tested 140/145 both cylinders....this is okay/strong right?! Ski ran so much better...def was issue of it being choked out. Need longer carb bolts because when I got new carb the old bolts are not long enough to...

some oil was dripping from my oil injection hose, got in the water and lightly coated the bottom...when water gets in there i bet it hits the muffler and creates a air thats not what it should be...great catch..ill have to clean this i switched and got blockoff plate any suggestions on if i...

I got an aftermarket intake manifold. < no size adjusting needed as its just bigger I can tune it and get it running good with the hood off, I Played with the jets yesterday..turned all the way in and turned each out 1 turn then adjusted acccordingly. With the hood off it runs superb!! Stick...

so just getting a 140-145 hi jet + tuning will solve my problem? its got a 1.6 size needle/spring in it now what route should I go with on that?

Its a keihin...i searched and found most people on this forum run a 42mm keihin .havnt found any 44s...not sure on size exactly. I am now starting to wonder if its a 42 as thats more common... I will see if i can find out. If it is a 42 what size then? similiar? The needle/seat combo that is a...

so then just order the jets you advised were needed above ? those are the same thats needed for a bigger carb? What do you suggest I order...and any places to order from?

1.6 spring on big carb.....pulled jets from the 28mm it was 125 and 48 with 1.6. Could I use either of those?

Big jet said k155 and little said k75. Could this be my nightmare to get it started issue? Where do I go from here?

^awesome thanks....and it will say when I pull them out?

Not sure what that means learning all of this...does the jet settings sound like my issue or something else....start over turn in and out 1.5 each?

87 650sx had fuel pump and 28mm Upgraded to 44keihin got from guy said had stock 750cc jets in it from a super sport Complete PAIN to start and once i get started it runs like raped ape. Ski feels twice as fast as before. Suggestions...figured fuel delivery would be approximately the...