Recent content by Freakie

You can just unscrew the bolt that holds the temp sensor in and pull it out and cable tie it away from the head....it will stay cool that way.....just be sure that your engine is cooling properly and you dont have sand inside the cylinder head or a blockage elswhere.

Hi...Do you perhaps have a set of valve cover bolts for the 1500 Kawasaki 4 stroke motors. (preferably stainless steel or new OEM) tks

From a non American perspective and from someone who has worked all over the world, including China and the US....600 million Chinese will work for a bowl of food every day. Their work ethic is incredible to witness. Every American who has a job of some sort demands minimum wage and those who...

Donor ski was a STX 1500 , 50 hours. Big Shout out to Dustin Motz @ FastPowersports who bent some rules to get me the hull and some of the custom parts to South Africa (Quality of the production is RRP level and more). and as always a huge thanks to Jetmaniac who comes through for us every...

Does anyone perhaps know the exact length of the stock driveshaft when the coupler is removed. Tried searching everywhere but no joy yet. Tks very much

I have used both H2O torrent and Solas pumps on my previous builds so my gut says go with an AM 12 vein setup but my donor ski is minty so I might start with the stock 148 (the motor is 1500cc after all....biggest I had so far is a TPE 1100,) so we shall see. :)....whats your experience on...

Hi there I followed your build on Youtube for the GP1R and based on that I hit Dustin up and now my hull kit is shipping any day now, as is my donor . So a huge thank you to you for getting me over the line, your content is very much appreciated. I will likely have a few build challenges...

are you happy with the result...I am just about in the process of dropping a 1500 from an STX 15F into a Fastpowersports F1.....any tips most welcome.

the small gap between stator and impeller limits slippage on hard acceleration...so never an issue unless you want a softer feel..then open the gap with spacers... ...i.e wave riding

The fins scare me a bit. When you bale it most likely to the front of the ski (no pole) so instinctively you think the board is going to hit you.

The quality of the product is next level though. Amazing attention to detail

I got one a year ago…been riding stand ups for 30years. My best ski is my freak with a tpe1105 Surf and flat water…..so the Jetsurf. Without the pole to help you stay on the board. It comes down to serious skills to be confident in turning and riding on instinct. That’s flat water. In...

best way to teach kids from 5 years old (my experience raising 5 ) is to first limit the throttle with turf rolled close in between the lever and cable tied so it can't get dislodged....so they get 1/4 throttle at best.....then you need to be on a sit down that can "sheperd" them in any...

Piston wash looks very lean...send pics of underneath the pistons...will verify lean issues for sure. pop off is way too high.....surprised the ski can even rev with no hesitation....get it down to 25 ish..else you lean in mid revs as well. I have stuck pistons on 75/140 with b pipe (wfo...