Recent content by firewhite

http://www.surfixinc.com/surfix_trailer_bunkslides.html Use this on all my roll carts and trailer bunks. Just make sure your skis are always tethered or they will slide right off.

Cylinders don't look to bad. Just keep in mind if you are running wiesco pistons, that they need a larger piston to cylinder wall clearance. Might be better off taking it to a shop for hone and piston fitting. Good luck on your project and keep us informed on performance when done.

Just read the for sale post on pwc today. That's got to be one of his cylinders. He is big on port matching intakes and exhaust manifolds. He does good work, I have known him for many years. I forgot in the first post but he did reshape the domes and shaved my stock cylinder head on my old...

Logo looks familiar. Hall's Precision Racing located in Glendale AZ. 623-931-8132 5814 North 52 ave Glendale AZ, 85301. I have a couple friends that have old vintage ski's that he built for them. Extremely fast 550 and 650sx with alot of expermental work done. He started as a mechanic for...

I have heard the square nose cover from Jet Tribe will fit.

Riva groovy ride plate. Tried a jet dynamics but put the groovy plate back on.

Keep goin on that cool build and be sure to post ride results.

How does the shredmaster compare to say a riva groovy?

Cleanest build I've seen yet. Hope mine turns out half as good Dogg. Just an FYI I have seen alot of the enhancers fail. I would run the Riva unit

Inside the carb where the fuel inlet is there is another screen that may be plugged up. You will have to remove the carb and just take the side cover off, you will see it. check that. Might as well get a rebuild kit while you have it off.

Here are some seal numbers I have ordered for my swap. Not sure how it will work out but wanted to pass this on to every one. Seals are SKF/Chicago Rawhide numbers 563167 single lip, fluro rubber, stainless steel garter spring 52x20x7 563168 double lip, fluro rubber, stainless steel garter...

When you go to your bearing supplier ask if the seal size in available with a stainless steel garter spring so it won't rust. I have a seal number in chicago rawhide with stainless spring but it's at work. I will post it monday night after work.

Hey Jinx check other posts in this section. There are bearing and seal numbers that will fit the yami bearing housing and kawi shaft. It will eliminate the need to send housings/supports out for machining. If you can't find them I can get them for you Monday.

:fing02:I was looking at them at the world finals. Almost bought a set but did not know if they would fit the gunwales of my fx 1. Pretty pricey but they looked high quality. 485 plus shipping. They were going to sell me a set for 400. I was so tempted to buy them.

Did not know that. Thanks for imforming me. All of you have help me out greatly. Thxs All