Recent content by fharrison

I made custom 1/4" stainless plates and used 1/4" shorter motor mounts. Then used a gp760 midshaft. It slid the motor back around 3 1/2". Fuel tank fit fine, even used an 1100 waveraider tank which has 3 extra gallons than the stock tank. Also, weight distribution is better.

The 1200 in that is very good. Swap an 1100 waveraider tank as well to get 3 more gallons. Have to do custom engine mounts though which I did with SS plates. Exhaust hits tank.

I think it was around $70. Holding up well after 2 years of all salt water use.

Rubber bumpers underneath line up exactly the same. Have to modify the straps or make you own. I put in extender blocks made of square aluminum tube from mcmaster and longer bolts since the straps are too short with the taller tank. No pics on my phone. Literally just replaces the b2 tank...

Waveraider 1100 tank fits. Adds about 3 gallons and is only a little taller. If the GP1200 is the same, it will fit.

You can make your own handlebar pull lever with a cheap mountain bike lever from ebay. They are like $7 a piece. Then call up Terry Cable and get a cable from the lever to the trim mechanism in the hull. You have to call them, they do not have a website to order from that i know of. You...

Yeah, I am not in a hurry to sell them. They have been sitting in my garage cabinet for a few months. Let me know if you want them later on. The plates fit a b1 or a b2. The rear mount is the stock location giving you the ability to use the original midshaft. The b2 midshaft is just a lot...

I have a set of the Ada plates I would sell for 150 shipped if you are interested. They work great, I used them in a blaster 2 last year and this year I made custom plates to set the motor back farther. Stock, the b2 midshaft is about 8". Anyway, only minor scratching and I did grind a little...

If I remember correctly, they are the same size as the rod holder on the carb n/s armature. I bought all stainless screws for my carbs from McMaster and those matched.

Just noticed you have a Surf City sticker, do you ride out of LBI much motoman3000? My brother and I ride the surf @ Beach Haven Inlet.

I have the 12/18 for my Yamaha B2 1100 w/ 1200 electrics and the hole-shot is excellent. Was told that the 13/19 may be better as I might be flying by the low end torque from the yamaha with the 12/18. Going to keep running the 12/18 until I find a deal on a 13/19 to try. I love the 12/18 though.

Can you rotate the pipe slightly? The end is cut on an angle if I remember correctly and that would raise the outlet.

I usually pull a wire from a wire brush and hold it with needle nose. Not the most advanced tool but it works.

I like them in Neon. Would take 5 more if you make them again.

I also want to do this to my RN and am looking forward to any advice that comes up in this thread. Sorry I have no advice though.