Recent content by fastony

looking for one 46mm Blackjack carb, I have 2 wanting to put them on my triple motor! Thanks

Yes with the early ac 2003 sxr ignition. Ran fine all day with the advent, I think it's time to ship it back!!

Yes I have resistor plugs with a jetnitics charging flywheel and there is no pulse settings just trigger settings its on 2 but have tried all settings. Just put my advent back in and it runs fine so I think it is a bad unit, it will start and idle perfect but won't go past half throttle with the...

Yes 2 humps and tried the other did not work.

Yes it is set at 47

Just installed my zeeltronics on my sxr 800 (actually it's a 920 dasa) and it has the wax programming in it, it starts right up but will not rev out and I have raised the rev limiter way up but it still only goes half throttle and boggs. Check it on a laptop and it seems to be doubling the...

Looking to buy a Zeeltronic ignition for my kawasaki 800 motor with dasa topend, does anybody on the site sell these? Thanks Tony

Hey Chris I am needing new handlepole bushings for my xscream adj. billet pole, do you have any? Thanks Tony

Dasa only uses wiseco and that is what I have I know cast piston are less but being the wiseco pro lite that is made just for them I didnt know if it needed the extra clearance? 180lb. compression ported Dasa 920

I had one person tell me .007 but that seemed a little too much.

Cant get anybody to respond and Kyle will not answer nothing Took over a month too get pistons and trying to get it bored, what clearances on the piston is the best to run on a Dasa cyl 89.5mm Thanks for any response!

Hey Chris looking for a Rhaas Products Kawasaki driveshaft Bearing Housing Complete, can you get it and how much? Thanks Tony

Is it glass or carbon hull, and how much just hull no pump?

Eric hasn't he had your motor for 3 months? Hope your Dasa cyl doesn't get dropped and your powervalve bellows don't fall off in the first hour of riding..