E350's latest activity
-
If your shaft is already trash just find another good stator and set what you have aside. Buy a low pitched large hub impeller, they... -
Are you turning it the right way? It's reverse thread.
-
E350 replied to the thread How to Remove 1994 SN SJ Drive Shaft?.^^^ @kevbo implementing method discussed in post #22 now . . .
-
E350 replied to the thread How to Remove 1994 SN SJ Drive Shaft?.Thanks @Roseand, yes I should have said that. I have the service manual and searched and read here and watched youtube videos and have...
-
E350 replied to the thread How to Remove 1994 SN SJ Drive Shaft?.Hey guys, I have heated the driveshaft to red hot and then iced it. I have also heated the oem aluminum impeller. I have a 1 1/16" or...
-
E350 replied to the thread The Opposite of Bogging FX-1/Super Jet.Well I found that the fuel tank intake vent air/water separator canister had 1/2" of water in it. So, I drained it and then...
-
Ive had that happen when the tank vent check valve stuck shut. It would idle and come to life near full throttle. It was confusing...
-
E350 reacted to WFO Speedracer's post in the thread The Opposite of Bogging FX-1/Super Jet with
Like.
No inside the carbs on the plate that holds the high and low speed jets , remove the two screws on the jet plate and look on the back... -
E350 replied to the thread The Opposite of Bogging FX-1/Super Jet.I don't really know what those are. Are they on the other side of the reeds which I can see from an inspection camera in the intake...
-
http://www.x-h2o.com/index.php?threads/how-i-assembled-my-solas-pump-without-a-press.137372/ You might read this also
-
E350 reacted to High Speed Industries's post in the thread How I assembled my solas pump without a press with Like.
Ok so before I start I'm sure some people will not like my method of building my pump. If you don't like it start your own thread. I...
-
E350 replied to the thread The Opposite of Bogging FX-1/Super Jet.Thanks WFO, probably why I was having problems attaching the cables to the electrodes. It sure seems like a carb problem. like there...
-
E350 reacted to WFO Speedracer's post in the thread The Opposite of Bogging FX-1/Super Jet with Haha.
Yes you have the spark plugs put in the wrong way .
-
1995 FX-1 with Single carb 701, MSD Enhancer, stock oem exhaust. Throttle cable is not hanging up. Runs fine at idle to slow ski-able...
-
-
The graphics from IPD finally came in and I got those put on. I also bought a cover from eBay to try and keep it looking nice! I guess...
