DylanS's latest activity

  • DylanS
    DylanS reacted to brapperdoodle's post in the thread 2014 Krash Predator - REVAMP with Like Like.
    Got the ski out on its maiden voyage, but didn’t get to rip too hard because of the new engine. Following the break in procedure...
  • DylanS
    DylanS replied to the thread 2014 Krash Predator - REVAMP.
    Wallow your holes out and send it!!! Always like coming back to this thread, exceptionally clean work!!!
  • DylanS
    DylanS reacted to brapperdoodle's post in the thread 2014 Krash Predator - REVAMP with Like Like.
    No, I just removed my 148 pump and now i'm installing my old Skat-Trak 144 Set-Back Mag. The 148 stator and "wear ring" were 1 piece...
  • DylanS
    DylanS reacted to Big Kahuna's post in the thread 2014 Krash Predator - REVAMP with Like Like.
    I would bolt up the stator section and check alignment. If alignment is good then shift the wear ring over so there is no offset...
  • DylanS
    DylanS replied to the thread Electrical Help Please.
    sometimes we must suffer (financially) to learn Lord knows I did Op will get there he’s on the right track!
  • DylanS
    DylanS replied to the thread Electrical Help Please.
    Battery acts as a buffer for transients and spikes in voltage. Regulator rectifier could have intermittent grounding loss due to...
  • DylanS
    DylanS reacted to WFO Speedracer's post in the thread Electrical Help Please with Like Like.
    It's a fairly simple process you can do at home with a five gallon bucket, battery acid, a piece of coathanger wire , some aluminum foil...
  • DylanS
    DylanS reacted to JC-SuperJet's post in the thread Electrical Help Please with Like Like.
    Yes, anodizing creates a non-conductive aluminum oxide layer on aluminum that serves as an electrical insulator. No Bueno for Ground...
  • DylanS
    DylanS replied to the thread Electrical Help Please.
    Bought a big 100 dollar set off eBay of them and that’s all I use for the total loss setups. Super easy to troubleshoot. Those and those...
  • DylanS
    DylanS reacted to Big Kahuna's post in the thread Electrical Help Please with Like Like.
    Have you replaced the positive and ground cables? If not, good idea where to start. and Install it to the starter bolt..........
  • DylanS
    DylanS reacted to WFO Speedracer's post in the thread Electrical Help Please with Like Like.
    Those type of crimps pictured on the cables suck period , I crimp connections all the time, for terminals I have the correct crimping...
  • DylanS
    DylanS reacted to JC-SuperJet's post in the thread Electrical Help Please with Like Like.
    For those who think that a bad Battery Ground location will not damage electrical components or cause erratic performance, go ahead, do...
  • DylanS
    DylanS reacted to JetManiac's post in the thread Electrical Help Please with Like Like.
    , Agree. For battery terminals, a large crimp tool or hydraulic tool is best for sure. For small terminals, a standard hand crimper...
  • DylanS
    DylanS reacted to Half flip95's post in the thread Electrical Help Please with Like Like.
    are you sure its not an intermittent start/stop switch?
  • DylanS
    DylanS reacted to JetManiac's post in the thread Electrical Help Please with Like Like.
    There is lots of good advice in this thread. I think you should find out what the issue is, or more likely issues are, “before throwing...
Show older items
Top Bottom