Recent content by delongsc

189

Just recieved mine, real nice piece. Glad I didn't mess around trying to build one. Thanks jetmaniac!

much better vids.. got my php today!

Waiting on mine to come in mail! Can't wait get some ride time.. Clause you need new vid as your getting good fast

recieved my flywheel but was busy to reply.. looks awesome and he was very fast at getting it done and back to me. thanks again

he is definately still doing flywheels.. just sent him one and its already done and on its way back..

what water box did u use??????

running a skAT SWIRL 19-24 WITH GOOD RESULT.... ARM YANKING OUT OF HOLE... ACTUALLY PRETTY FAST TOO..

have coffman sizzle if interested 400 shipped.... runs great its on my machine right now.. just have a buddy with true factory b pipe he would sell me but it will cost me 600.00..

skat 19-24 swirl also good improvement ... still running it!

i also ran a new line i just used 3/8 copper tubing for line.. i ran mine just above or just below original cooling line. taped pump on oposite side.. i agree its thin i threaded fitting in to pump them grinded it down with grinding bit flush with pump.

i have a full coffman sizzle for 300.00 if your interested. it runs pretty darn good

cutting box and getting ready to glass

i mess up writing.. i have epoxied footholds in.. i foamed on side almost upside down so the foam didnt run down.. i also forgot to mention that the end of gunwales were cut off by 2.75 inches at end of footholds kindof like what turbo did..

foam ndidn' well i have in my foot holds and then i started foam.. i used closed cell foam for bottom then i just put alittle foam on top to give shape.. i waited till it was pretty sticky before i poured so it would go down... i foamed gunwales on side almost upside down so foam go down...