ClumpDigger's latest activity
-
ClumpDigger reacted to WFO Speedracer's post in the thread How to Remove 1994 SN SJ Drive Shaft? with
Like.
A new midshaft , you replace the midshaft and the driveshaft as a set when that happens , it the driveshaft has that kind of wear -... -
Anytime , by helping you I am helping myself lol .
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.Got to 42mph on phone gps and I started spilling my beer. Certified ripper.
-
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.She rips with the mako 60 prop and a stubby pump cone. Thanks for all the help
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.Thanks for the help guys I appreciate it. I got the pump out and put that mako prop in, it was in a lot better shape than the skat trak...
-
Mako impeller , they were sold through Kawasaki accessories division back in the day, yes it is most likely a 16 degree straight pitch...
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.So I got 2 props laying around, one came with an X2 I bought and the other one I’m not even sure where it came from. The one that says...
-
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.Yup at the beginning I ohms tested the stator, coil, trigger everything was good. Spark plug leads would jump a 1/2” gap on my spark...
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.yup same here i had a 650 in it with a prop and pump stuffer she had way more power and did 39mph. would have never guessed it would be...
-
I also ran into the same issue on my Jetmate build. I swapped from a stock 650 setup with a 9/17 small hub skat to a BP 750 & factory...
-
The big pin 750 cylinders make less low rpm torque than 650s do. Solas finally made their 750 small hub concord impellers very flat but...
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.the fitting on the pipe isnt swapped
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.i believe so, i will double check when i make it back up there.
-
Not 100% sure, but I believe the chicken uses an odball nozzle that is aluminum and 82mm, but the location of the bolt holes for the...
-
ClumpDigger replied to the thread Superchicken wont hit max RPM.I noticed the water fitting on the cylinder head of my 750 was swapped from the 3/8ish size tapped to a 1/2 for some reason and thats...
-
