Recent content by Chris Pausch

Pmed about pump parts

I sent you a message about some of the pump components.

Still available? How much for everything but the motor mounts, engine (longblock), pipe, ebox, and midshaft?

Is this still available?

pm sent

Location? Are you interested in any trades?

Anyone still need to go to the launch? I'm heading there by myself and kinda need a ride..

Sooo, there's no sites left... Anyone want to let me and a buddy pitch a tent on their site?

So I made a makeshift tester and I'm getting almost 30 psi with my 95g spring. The other two are about 23 psi and 18 psi. I put a new 1.5 needle and seat in when I rebuilt the carb. it pops off clean then leaks down a few psi before it seals back up. Is this normal? Any idea where the pop off...

When I rebuilt my carb the kit came with 4 springs. One (the biggest one) appeared to be the same size as the 95 I ordered. Then there was one a little smaller, and another a little smaller, the last one I had looked to be the same size as the other smallest one I have. I have tried every size I...

Can you explain that a little more? I have a 144 solas mag with a new 9/15 hooker.

If there was an air leak at all, even a small one, wouldn't it have a hard time running at idle and not reving up. It starts and idles fine. So it sounds like you guys think I need to try some different jets, I'm gonna have to order some. I will get a 127.5, any others I should order while I'm...

Butterfly looks fine. Are you talking about the seals on the shaft the butterfly connects to? I will have to check those.

Tank has a check valve on it, and yes in the right way lol

Pretty stumped on this one. I recently built my first am ski. Gen 2 bob. When I snap the throttle from low rpm to full it cuts out but doesn't stall. The rpms galop a little but won't pick up. When I pull the throttle to 80% it hits hard and if I pull it to 100% a little softer than a snap it...