brapperdoodle's latest activity
-
super cool survivor of times past hope it goes to a good home -
brapperdoodle replied to the thread Freestyle Hot Tub!.
-
-
I just don't understand why the fishermen think I'm weird?
-
brapperdoodle reacted to Talsivar's post in the thread New Factory pipe limited chamber and manifold. with
Like.
Here’s some pictures. Thanks for the offers but not interested in $250 -
brapperdoodle reacted to fastgtfairlane's post in the thread BA Freak (155 conversion) & carbon circus with Like.
I have solidworks and could probably design a ride plate and 3d print a mold to make a carbon or glass plate. I also have the glass...
-
I swapped my yamaha start/stop switch to a polaris slt one that has an extra momentary button built in. Easy to take apart and clean...
-
brapperdoodle reacted to mostexcellentdude's post in the thread What should I do with this old square nose? with Like.
I have a 62T swap and my buddy has a 61X single carb, both in SN skis. Both high comp heads, bpipes, mag pumps, etc. They pull basically...
-
brapperdoodle reacted to DylanS's post in the thread BA Freak (155 conversion) & carbon circus with Like.
About wrapped up for the trip with a few major takeaways. Malone actually stopped out at the lake and barrel rolled the ski and stuck a...
-
brapperdoodle reacted to fastgtfairlane's post in the thread What should I do with this old square nose? with Like.
Put a decent 61x engine in it stock pipe and sell it. Would make a great first ski for someone
-
brapperdoodle replied to the thread Suggestions For Repairing Damaged Brass Hull Inserts?.You can also call Rotaloc directly and order specific inserts if McMaster does not have what you’re looking for
-
brapperdoodle reacted to WFO Speedracer's post in the thread Suggestions For Repairing Damaged Brass Hull Inserts? with Like.
They are called adhesive mount nuts , available here : https://www.mcmaster.com/products/weld-nuts/stainless-steel-adhesive-ready-nuts/
-
brapperdoodle replied to the thread Suggestions For Repairing Damaged Brass Hull Inserts?.I've used these as drains for the tray, they are great but very soft. I'd use something like this, the underside is sealed already so...
-
-
If you already have them, no reason not to try one. They dont load the engine as hard at lower rpms as a big hub swirl type impeller so...
-
brapperdoodle reacted to fastgtfairlane's post in the thread RRP FLow Guard on a Surf Ski with Like.
Oem nozzles for surf. Because they're cheaper to replace when they break. For surf/boat chase ski 62t nozzles. Obviously depending on...
-
brapperdoodle reacted to DylanS's post in the thread BA Freak (155 conversion) & carbon circus with Haha.
