Recent content by blowout169

im pretty sure chris maros made the first foot holds but there were lift wedges out first

i was just at his shop this weekend and the pump look amazing thread will be coming soon and pricing

Ski is around 230lb and I'm like 175lb

i have a full carbon team bill outlaw hull and i am and i bought a solas mag pump and i have a 846cc motor what kind and pitch prop should i start with

i built a 90mm piston with stock stroke and i need to get my dome cut where or who can cut them

These hulls will be available in begining of june in various options.comming soon will be more pics a final actual weight and pricing. hulls will be available in carbon and fiberglass layups also complete hulls and hull kits will be available. Any further interest contact...

what companys sell or who can i call to get a cylinder for a 4 or 5 mm stroker motor. billet or cast and im using flat top pistons

that is carbon / fiberglass

new picks of the battery box

they will be starting around $4000

Send me pic of it blowout169@comcast.net

the force of the water going back into the bulkhead when you hit the gas and the angle of the ski when the nose is up should allow the water to go up that lip and right out and with two of them that water will be gone before the nose even comes down

re yes that what its for. me and billy are putting two scuppers in the first two hulls with the gas caps. its perfect for when your out on the lake and want to just tie off to the boat and dont want to worry about it taking on water.

we decided to build another new hull. this one buy far will be the best one. we made it a good bit shorter and a hair wider. there are a couple other mods we did to it like moving the pole forward and changing the pitch of the nose. the best part of the new hull is that it will use a...

turn your idle down and zip tie it