I have a 2014 SJ and it only chine walks a little bit between half and 3/4 throttle but I just gas threw it or don't hold it there. Only does it when on glassy water. The lake I ride on has lots of boat traffic so it hardly ever happens. Also I'm 6' 2" and 285 pounds for weight comparison to...
I asked this same question before when switching bars. Everyone says to grind the plastic nub off but i just drilled a new hole in the bar the same size as the hole on the old bar. Peace of mind believe the nub is there to keep switch from turning on the bars. Not very hard to measure where...
I ride every couple of days or atleast every weekend almost. I dont worry about the carbs during that time just turn fuel selector to off when traveling though. A good yaulsa battery will last multiple season on one of my skis battery is a least 6 years old. Just remove from ski during the...
Any word on stock water box with b pipe wrecking motor. Aftermarket needed or not? I just like to blast around the lake and try to do some basic tricks on it.
What would you do with a budget of around 1200 dollars to spend on your ski? Ski is a stock 2014 superjet with only basic stuff done:
odi grips
blowsion endcaps
blowsion finger throttle
blowsion pump cone
complete dual bilge pump kit installed with OCD harness
I was thinking ada girdle head...
Just put new grips on stock bars with billet finger throttle. Question stock bars have hole where the start stop switch piece of plastic goes into bars with new grips this hole is in wrong spot. Is it ok to file the plastic lip down on the switch or do most people redrill the hole were they...
I'm with you on that one! I live in the UP of MI and its just a bit colder! Nice job of snagging a 2014 hull you don't have to worry about water logged foam now. I have a 2014 also!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.