Recent content by bigtimemotorhead

I recently picked up the HX3 and wanted to test out some curves. Are these old curves ok to run on the HX3? I'm running a 771 Big Bore, B-pipe and want to get the most bang.

I searched the thread but didn't see anything related to my setup. 61x 84mm Big bore, ported, Bpipe, 180psi. Looking for recommendations for Single SBN44 or 46mm. Thanks!

Will anyone with the 964 be going to the dells free ride or the tcjp sortie? Really want to try before I buy.

Lots of great guys that are happy to help you, I'm happy to once it warms up some. But I'm also in forest lake. Try posting in the tcjp area. Post here, http://www.pwctoday.com/forumdisplay.php?f=89 Or here...

So I did extensive pop off testing and found 1 of the carbs had a leak on the fuel pump side. I rebuilt the carb and its not leaking fuel anymore. My low end is now too rich. I went down to a 120ls jet and increased pop off to 25psi. The ski runs much better but still has low end bog, mid...

I think my carbs may be getting too much fuel and may be sputtering? Is the pop off within normal range? Not sure if I need to rejet.

I built a BB771 motor and I am trying to dial in the carbs. When I was out tuning I noticed that the carb seemed to be really milky on the outer body and also in the air box. Not sure if my low speed jet is too big or if my pop off is too low. Any help would be appreciated. Mikuni Dual sbn44...

Nice No Hander 5:26!

U buy it?

I've heard the horror stories. This things gonna take some time and effort to put together.

plexus ma530, where and I find this or order it?

Hi I am starting to build a highroller customs light weight octane hull and wanted some input on what to use when putting the hull halfs together? 3m 5200? Thanks chris

Hi i have a 650sx with a 750 motor. piped, head, intake. What would be a good impeller for freestyle? Anyone have one for sale? Thanks

Need advice for setting up a dual 44 sbn carbs. Just installed a 62t ported case with ported 61x cylinder. Not sure what to start with for jetting specs. Anyone have any idea what size jets i should start with? I am also running a protec pipe. Thanks!