Recent content by AlexC651

I see that it is just a carb plate. I can't seem to find anyone with a 66e using an actual speed plate. Wonder if I can use the gp800 plate to manifold gasket and use a 49mm hole punch and make my life a little easier? Worth a shot!

I'll shoot him a FB message. Haven't been lucky enough to get a reply before

That is a feat only achievable by the jet ski gods themselves!

I'm using green gaskets from Troy but the bolt holes domt mach up so I had to cut the tabs and they are a HUGE pain to line up.

Not sure what speed plate this is but it does not have cuts for orings on the bottom. Kinda annoying because I have to use carb gaskets and cut the bolt hole tabs to fit. Engine is 66E 927. The manifolds are wdk twin. Carbs are full spec 49s. Wondering if anyone had one already cut for 49s...

That would make sense why they went bankrupt but realistically it shouldn't cost that much

Still available?

Looking for a beach dolly. Doesn't have to be the prettiest. Just usable

Did that really work for you?

Looking for a pair of GP800 kidney blocks for my sbn46s

Looking for a 9/15 for my 927 in a eme aerial 8 with a 155 pump 90mm nozzle

Looking for a 9/15 Not cutback for my 155 pump. Currently have 927 in my aerial 8 and a 11/17 is too tall.

Pm sent

Bump

Looking for 49mm carbs and a speed plate for my 927 66e