Recent content by 600h.o.

I almost sold my superjet and bought an SXR untill I found and installed tubbie destroyers... I was very sick of skating through every corner wondering when it was going to catch and when it was going to slide..... If you look at the old hull design of the square nose or pre 08 superjet...

Blowsion Tubbie Destroyers for sure.....They make a black and white difference in handling... Worx Dominator Ride plate works very well also. but definatly the tubbies first.... Do you have a Pole Spring?

That was my thoughts, especially since they are discounting the 14's so much... Where and how did you see one?

Any thoughts on what to expect for 2015? Our local dealers have been using the "they are not making them anymore" sales pitch since 2009!!...lol I saw a old thread on OZ freeride with talks about them expecting to see changes in 2015.. but that post hasn't been active for a while.. I think...

Cool, looks like its in good shape!

I am very happy my advise worked well for ya!! Its funny... but....I put a Riva Spring in my 2012 Superjet with no issues, just a little finess, grease, and a rubber mallet!.. But when I went to put a Blowsion Spring in my 2014... It was a nightmare!. My luck with the quality of Blowsion's parts...

Just went through this.... after 45 minutes of not being able to get the bolt to slide through the center of the spring and line up with the threaded hole in the bracket..... I had to make some decisions.... What I decided to do was...CUT. 1/8" to 1/4" off from the bottom of each spring rod.. I...

Thought I should update everyone. Prior to recieving the pipe, I removed the carburetors, drilled a 13/64 hole in each of the brass block off plugs, tapped them with a 1/4-20 tap and used a deap well socket, a 1/4 -20 bolt and nut as a puller to remove them, worked super slick. I changed the...

You may get a kick out of this, But who makes the flow controll valve and how does it work?

West Central MN, where.....as of today, most lakes still have some ice coverage.......lol

Thanks for the replys! The more info I gather the more confidence i get for the install!

Are you running stock airbox or aftermarket arrestors?

My elevation is more or less identical to the elevation stated in factory pipes setup. The pipe is supposed to be here the middle of next week, I am just trying to gather as much info as I can before I start the install and setup. Thanks

After Many Years of riding my stock 2006 Superjet (w/aftermarket impeller, ride plate, and intake grate) , I finally decided to Purchase a Factory B-Limited Pipe kit. I have Two Main questions!?? #1--- If I folllow the recomended Jetting and carb settings as per Factory B-Pipes Instruction...

I have a works D cut dominator ride plate. You do have to drill three small holes in the hull to install the destroyers, Very Simple install. The handlbars are blowsion 4* That I actually cut 1/2" off from each end.