I recently put an X2 together and took it out for the first time and had a powere problem. It started up fine and went great out of the hole for the first 3-4 seconds.... after that i slowly lost power.... it slowly lost rpms and you couldnt give it more then 3/4 throttle... about minute later you couldnt give it more then 1/2 throttle and then another minute later youcoudnt give it more then 1/4 throttle before you were eventually feathering the throttle..... if you gave it more throttle it would die out....
The motor had top end gaskets put on last week with RTV copper seal (spray can)... its stock other then a 44 mikuni, boysen reeds, and jetsport intake... I tryed playing with the carb a little bit but that didnt help... i also checked the plugs and they look good (light brown)... im thinking it possibly might have an air leak when it gets warm... any ideas?
*** Note the motor isnt over heating... its never to hot to touch nor does it sizzle water...
The motor had top end gaskets put on last week with RTV copper seal (spray can)... its stock other then a 44 mikuni, boysen reeds, and jetsport intake... I tryed playing with the carb a little bit but that didnt help... i also checked the plugs and they look good (light brown)... im thinking it possibly might have an air leak when it gets warm... any ideas?
*** Note the motor isnt over heating... its never to hot to touch nor does it sizzle water...