hey guys wondering if anyone knew if aftermarket gp1300 sleves will fit in a 66e cylinder . i know 1200 sleevs are the same size as the 66e but you can only bore out to 84mm so i was thinking if 1300 sleves fit , they are starting at 84mm so you could bore bigger ???
Will gp1300 sleevs fit in a 66e cylinder ???
- Thread starter spoto
- Start date
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
Forget the sleeves; just bolt on the GP1300 cylinders & pistons.
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
The 60T non-PV cylinders have lower port timing more suited for a 66e freestyle engine.
I wouldn't recommend boring the cylinders and re-plating them because it just doesn't hold up as well as the original coating.
I wouldn't recommend boring the cylinders and re-plating them because it just doesn't hold up as well as the original coating.
WFO Speedracer
A lifetime ban is like a lifetime warranty !
- Location
- Alabama
By the time you have the cylinders bored to accept the sleeves, buy the sleeves and pay to have them installed you could have bought a set of used 1300 cylinders, you would still be stuck with cast iron sleeves that do not transfer heat as well as the nikasil cylinders JMHO.