Whose Shortened Quick Steer set up on Ebay

[SXIPro]

Ok, which one of you guys makes this? :sneaky:

http://cgi.ebay.com/ebaymotors/ws/e...70207624026&ssPageName=ADME:X:RTQ:MOTORS:1123

 

[oxnard111]

what do you all think? does it use a UMI bearing kit? Or stock? I see that large bolt and nuts. I also DO NOT see a recess for the UMI o rings.

 

[The Penguin]

it also looks like it does not have the recess like the new x-metals do

looks like it just bolts on using the bolt, washer, nylon spacer and 2 nuts.

homemade maybe?

 

[SXIPro]

what do you all think? does it use a UMI bearing kit? Or stock? I see that large bolt and nuts. I also DO NOT see a recess for the UMI o rings.

Apparently it reuses the stock bushings based on a reply I received.

And yes, Darin, if you're reading this, If I buy it I'll run it through the X ebay adds link.....

 

[SuperJETT]

Apparently it reuses the stock bushings based on a reply I received.

And yes, Darin, if you're reading this, If I buy it I'll run it through the X ebay adds link.....

Very well my son.

I have a similar setup, I use a Blowsion short turnplate (made to work with UMI) with the stock bushings and a custom aluminum bushing that freestylegeek made for me years ago. It doesn't stay tight, I'm replacing it with UMI soon probably.

The hardware in this 'kit' looks like junk, like galvanized bolt/nuts and carbon steel hex heads.