Super Jet Which Footwells are these?

[Alaska700]

I bought the ski with the footwells already in. Which one do these look like? I was thinking the digger but im not 100%. I want to be sure before I order one of the Mat kits for it. Thanks in advance.

 

[Ducky]

Its hard to tell what footholds those are with the turf in such bad condition and all over the place. Maybe someone else can tell you for sure, but there are lots of foot holds that are fairly similar.

You should just buy a sheet of turf, and learn to turf. You will save yourself a bunch of money, and learn a new skill.

 

[burton148]

I recommend just buying a sheet of turf and doing it yourself. The precut turf kits never seemed to be cut right for me or they were a little small.

Its not hard to turf yourself and theres some really good threads on here thats full of information

 

[Alaska700]

Okay, I'll start researching DIY. I'm definitely adding some padding too

 

[burton148]

http://www.x-h2o.com/threads/15259

 

[TheBuzzard]

they are insufficient holds for sure. good for having your feet come out on anything but straight air jumps. if you plan on doing anything extreme, get those out of there now, before you get killed

 

[Alaska700]

they are insufficient holds for sure. good for having your feet come out on anything but straight air jumps. if you plan on doing anything extreme, get those out of there now, before you get killed

Which one would you recommend? I have huge feet, size 16s so the klowners look like the most functional for me. I have a feeling the foam underneath might be water logged, as I saw water leaking out under the turf.

 

[Joker]

Which one would you recommend? I have huge feet, size 16s so the klowners look like the most functional for me. I have a feeling the foam underneath might be water logged, as I saw water leaking out under the turf.

If there is water in the tray you need to cut her open and take it all out. If you do this you should reseal all of the lines that run under the tray. As far as footholds go, those suck! I'm not sure on which ones you need to fit your feet but make sure that you can put the 26mm padding in the tray an some 8 on top and still have from for your feet.

 

[djraider700]

Kinda look like my Rickter holds. I agree that you should get a sheet of turf instead of the mat kit. I have the mat kit on my ski and it sucked.

 

[TheBuzzard]

i think the rickter adjustable holds are by far the best, but if you are cheap and dont mind doing glass work, making your own. i got the sawsall out and hacket the back out of my roundnose, so my feet kicked straight in and were all the way in the rear. if your ankles can hit the tray sides, they will on roll landings and it hurts bad. i took the shoes i wear and wrapped them in plastic wrap, then foamed them in. after it dried, pulled them out, shaped the foam and glassed over it all. custom holds specifically to your liking.

 

[sjetrider]

they are insufficient holds for sure. good for having your feet come out on anything but straight air jumps. if you plan on doing anything extreme, get those out of there now, before you get killed

its a square nose, whats he gonna do on it, stabs and rolls maybe. They are not insufficient, just outdated much like the hull for serious freestylers anyways. They aboth fine for freeriders IMO.
They look like the older Toby's and they dont make turf kits for all specific holds. A roll of sheet turf , cut a pattern from paper to transfer to turf and have a heat gun handy. Start your pattern on outside edge of gunwell holding the sheet straight up whilealligning the outside edge. Then roll it over towards the inside a little at a time, heat and roll it into the foot hold.