Super Jet start stop switch, internal rubber boots, parts?

[davy87nj]

I was wondering if its possible to obtain parts for a start stop switch. Rubber boots, individual switches. I have a couple good couch s/s switches. I pulled one apart trying to figure out if its possible to repair these on my own. I see a marking on all the switch housings, its a A and a D in some logo form. Figured I would attempt to reman and extend one of these before sending to JSS. If anyone has any info that would be great. Maybe save me some money.

 

[OCD Solutions]

Some parts are available like the springs and boots but honestly, you can't touch them for what John rebilds them for. I looked into gearing up to repair them at one point and JSS pricing is lower than my cost on material alone and I was never able to track down any of the very special crimp on terminals they use inside the lanyard switch.

I lucked out a few months ago and found a complete drop in replacement harness that included the long harness, OEM connectors and all switches in OEM plastic still. it's from a SN but should work in either application. Personally I feel that is the way to go as it only takes a few minutes to replace and it's 100% OEM reliability.

Here is the thread.
http://www.x-h2o.com/threads/113610...ken-shorted-or-damaged-start-start-assemblies

 

[davy87nj]

I ran across that harness while researching also I couldnt tell from the microfiche if it came all together, but looks like it does. I was looking at JSS pricing for the reman s/s switch and yeah thats hard to beat. Ill probably go for that harness deal. thanks