running 3 pissers, where do they hook up?

[demolition_x]

might be a stupid question

one person i saw had three pissers all being fed by the 2 leads off a head. really only needed 2. lots of fittings to make it work but i didn't see a reason. others i didn't see where they were hooked up to.

where are pissers suppose to be hooked up to?

 

[Speedfreak]

You would only need 3 pissers if you have dual cooling. I have one off of each side of the head and the other one is off of the pipe.

 

[demolition_x]

like in line with the stinger?

but doesn't the pipe get fed from the rear head outlet and gets split into pisser and pipe?

 

[Speedfreak]

I have a speedwerx pipe and one inlet is feeding the pipe only then there are 2 outlets from the pipe. One goes in to the exhaust at the end of the stinger and the other goes overboard.

If you feed the pipe with the water from the head then where is the 2nd incoming line going

Just found this picture pretty well explains it all Thanks Darin
http://www.x-h2o.com/attachment.php?attachmentid=3566&d=1143384841

 

[IceRocket1286]

dual cooling with 3 pissers
2 in lines, one to the bottom of the head pipe, one to the manifold which is sometimes T'd off to both sides of the manifold, personal choice.
2 lines OUT of the head, aka 2 pissers
1 more line OUT. This out comes from the T in the line from the head pipe to stinger.
3 pissers, done

dual cooling with 2 pissers, how I ran mine...is like this. Like the Octanes

2 lines in, one to each side of the manifold.
2 out of the head, one is a pisser and the other goes to the bottom of the head pipe.
1 line out from the T in the line from the head pipe to stinger.
2 pissers, done.


I see some guys with 4 pissers, but it all depends on how crazy you want to get with your water routing and drying out your exhaust. those two should be fine for you.

 

[demolition_x]

so would drying out my exhaust be a bad thing.