Rancid
X
- Location
- Houston, TX
Will this VXR Riva Red Pipe fit and work in my Blaster 1? If so, where can I get new gaskets? Thanks
Ian
Ian
Riva Red Pipe for VXR fit into a Blaster 1?
- Thread starter Rancid
- Start date
Mike W
Infidel
- Location
- North Florida
That pipe will fit. The gasket you can get from Riva I'm sure. If not you can make it youself.
riva doesnt have the exact gasket, but they have one thats VERY close to it. you just have to elongate one of the 3 bolt holes to get it to work. no biggie. good luck describing it to them and getting the right one though.
Rancid
X
- Location
- Houston, TX
Nice! Thanks guys.
Mike W
Infidel
- Location
- North Florida
I used to run a riva pipe and I think I have a spare gasket. I will look when I get home and let you know.
the red pipe makes killer power.
MAKE SURE TO RUN A GIRDLED HEAD!
MAKE SURE TO RUN A GIRDLED HEAD!
Rancid
X
- Location
- Houston, TX
I've also been searching jetting suggestions for the WB1 single carb, but I can't find anything. Sea level, high humidity. Should I just call Riva when I get the pipe? Will they also sell the jets I need?