Problem with SN cooling

[Coconnor31]

I have a square nose set up with a 701 and dual cooling. I'm having a problem keeping the pisser running strong. When I first get on the water it cools correctly. Then after riding a few minutes the water slowly comes out of the pisser but never stops completely. I've blown out the lines easily reached and have been sure not to get any sand in it. I have one of those resistors going from the head to the wet pipe, I am not sure if this could be causing it or how to use the resistor at all. Any help would be great.

 

[Mike W]

I have a square nose set up with a 701 and dual cooling. I'm having a problem keeping the pisser running strong. When I first get on the water it cools correctly. Then after riding a few minutes the water slowly comes out of the pisser but never stops completely. I've blown out the lines easily reached and have been sure not to get any sand in it. I have one of those resistors going from the head to the wet pipe, I am not sure if this could be causing it or how to use the resistor at all. Any help would be great.

It sounds to me that sand or trash is blocking flow through the restrictor. Try using a slightly larger restrictor. I use 3/8" nylon spacers from Ace Hardware. You can get them with different size holes or you can just drill them out to the size you need.