- Location
- amarillo ,tx
Im fixing to start foaming under my tray with polystyrene foam, and should i b worried about the foam touching the exhaust there and melting.
Super Jet polystyrene foam questin,
- Thread starter txsuperjetfreak96
- Start date
btmboards
Brett
- Location
- Oceanside, Ca
hope not becuse that how I did mine last week. stuff doesnt burn though. may melt a little. I dont think it gets hot enough though
- Location
- amarillo ,tx
yeah what i thought at that perticular point in the exhaust styeme, ive got the sheet of foam setting on some saw horses useing it as a make shift table to cut my biax on, ive set a cup of resin on it, when it starts getting hot it will start to kind of melt a lil
btmboards
Brett
- Location
- Oceanside, Ca
ya I will just a little but for the most part if I mix my resin hardener rich then the curing resin gets hotter than that part of the pipe. unless you are racing full out it isn't going to get very hot. While riding reach in and feel your long rubber tube or the metal where that connect before going through into your tray. it is little more than warm. you would have a hard time melting butter at that point. On top of that every time you fall or stop that fills with water and cools it completely. I have no worries about it.
- Location
- Cleveland Ohio
SXR waterboxes actually sit on polystyrene without a problem....should be fine in the back.
- Location
- amarillo ,tx
awsome sounds good, didnt think it would b a prob