pluging fittings

[chrisdoc0608]

where do you get the rubber pieces that go over a fitting to block it off.. in this case a 3/8'' water fittings off of the head (pictured) and off of the rear exit pipe on a sj

i could use a piece of hose with a screw in the end and some silicon, but it looks a lot cleaner with the rubber caps.. i just dont know were to get them.

 

[Frosty]

you can pull that brass barbed fitting and replace it with a brass plug from the hardware store.

 

[chrisdoc0608]

you can pull that brass barbed fitting and replace it with a brass plug from the hardware store.

i guess that is an option, but it would require me to do more work :nono:
the fittings would just slip on and be zip tied on or clamped... lots easier

 

[Frosty]

i guess that is an option, but it would require me to do more work :nono:
the fittings would just slip on and be zip tied on or clamped... lots easier

lol... not much work... unscrew the fitting... screw the new plug in...

or you can clamp a flush kit on to that fitting...

 

[chrisdoc0608]

well there is a toatl of three fittings to plug.... i thought abt getting a real flush kit and putting it there... the one i have now i just plug into the pisser line, i made it so it doesnt have anything to stop water from coming out throught it if i leave it connected all the time.

 

[Big Kahuna]

your best bet is to remove it barb fitting and use a 1/8th pipe plug with sealant.