Looking for stator specs to check out a wavejammer 500

[Speedfreak]

This old beast (1989) has the 500 motor but no spark. I just put a new coil in. It was shorted out and still nothing. Disconnected the start stop switch checked all grounds. checked the whole system with an ohm meter to make sure there wasn't a loose wire or a bad ground. I have 2 hours in this thing troubleshooting. This guy doesn't want to spend $350 for a new cdi so I need to check the stator first.

Any specs or suggestions?

 

[loictahiti]

I have the service manual for WR 500 R, I suppose it's same engine , so you could check with that :

charging coil (brown/black) 90 ohms +/- 10%

pulser coil (white-red/black) 102 ohms +/- 10%

lighting coil (green/green) 1,0 ohms +/- 10%

ignition coil primary (orange/black) 0,15 ohms +/- 20%

secondary (hight tension cord) 3,5 K ohms +/- 20%

hope you find with that

 

[Speedfreak]

According to the part numbers the wr and the wavejammer have different cdi's but the colors seem right. I will check tomorrow when I get to the shop. Thanks

 

[Speedfreak]

OK so I have the wires mentioned above and this stator has 2 wires that are white with black lines that are grounded inside the ebox.

I have 1.9 ohms on the lignting coil the green to green test was almost double. Does anyone have any used 500 parts??

 

[WFO Speedracer]

9 times out of 10 its a bad CDI on those, I have a good working CDI here if you need one and a few stators laying around also.

 

[Speedfreak]

I'll take it. What do you want for it? I have one here but none of the wires match. So I don't know what it is for or how to wire it up.