Jetski Stand Questions

[StandupWI]

Alright, so I am going to build a stand for my superjet because I plan on putting in some footholds and reinforcing the ski. So I thought that a stand would be helpful, however, I need some dimensions. How tall is you stand from the ground to the bunks, how long is your stand or bunks if the bunks are longer, and how far apart are the two bunks width wise? Thanks in advanced.

Peter

 

[the only couch rider]

take the measurements off your trailer and go from there

 

[Boris]

My stands bunks are 36" long and they are 12.5" on center.
The height is adjustable (screw in PVC fittings with different lengths of 2" pipe) buy 19" works good for me.

When I did my footholds and all that fun stuff I dropped my ski onto a blanket on the ground.
This allowed me to lay the ski on the side if needed.

 

[Frosty]

baically make it so you can work on any part of your ski comfortably. I think I made mine so that is was set up like my traile in terms of bunk hight and width. and Like Boris said, i think mine are about 36"in length. I angled my bunks too.. and when reinforcing the sides I can set my ski on it side on the stand without worrying about it falling over...

made completely from 2x4's, and lagg bolted together. The bottom has a piece of 1/2" plywood for a tray and I used large, lockable casters. I also covered the bunks with the same carpet that is used on trailers.

the whole thing works very well and I have been using it now for like 5 years.