Super Jet How to Stock Throttle on UMI Bars

[djkorn1]

How do you attach a stock Throttle onto aftermarket bars....

There is only one screw and it just spins in the hole in my UMI bars. Should I drill all the way through and just put a nut on the end? :chairshot:

 

[djkorn1]

help me...lol

 

[djkorn1]

no helpy???

 

[MADMAT]

Korny I think the hole on the bars is for a pin on the stock throttle to sit in. Then the throttle lever just tightens around the bars.

??

 

[djkorn1]

hmmmmmm....let's see........

 

[Big Kahuna]

or you have the bars on backwards and the hole is for the start stop module

 

[djkorn1]

How do you tighten it then?

 

[Big Kahuna]

you place the finger throttle exactly where you want it and take a drill bit that is a tad smaller than the screw and drill a hole. Then use the screw to self tap itself into the bars.

The hole that is there is for the start stop box, there is a small tit that will sit in there to keep the module from rotating.

 

[djkorn1]

Damn...that is one ghetto setup...Thanks BK!