How much to get HIN tags made up?

[OCD Solutions]

Stainless would look better. oke:

I don't know about that, everything on this ski is black.

Since I figured out how to use the machine I've been approached by 3 co workers already asking to have projects done. :banghead:

 

[snowxr]

Michigan has a strange loophole in the books regarding assembled vehicle vin numbers. You can make them from whatever you want, any size you want. You'd even be allowed to grind the number into your hull. My next ski could have the hull i.d.# 6"tall down the side of the ski. That'd piss off some marine cops!

 

[OCD Solutions]

Each HIN must be carved, burned, stamped, embossed, molded, bonded, or otherwise permanently affixed to the watercraft so that alteration, removal, or replacement would be obvious. Use of a plate must be fastened so that removal would cause scarring or damage to surrounding hull area. HIN characters must be no less than ¼ inch in height and not attached to any removable part.

Even our rules are pretty forgiving. i figure as close to OEM as I can get the better.

 

[snowxr]

I just want to see the water cops face when he asks to see my reg. and vin. WTF!? are you blind?? It's 3 F---ing feet long, dillwed!