Super Jet 62t ebox stator wires please help

[mike b]

I disconnected my stator connectors within my ebox because I was planning to separate the two at one point but I went back to keeping them together. I wanted to double check that my wires are connected correctly. I have a MSD enhancer and was wondering if somebody has a link or diaghram of the wiring route. OR if anybody has an ebox open and can snap a few pictures for me or help answer where a wire or two goes. Stock CDI is fine because wires should route the same way. THANKS in advance- mikeb

 

[N3vrSat1sfied]

http://www.x-h2o.com/index.php?threads/how-to-msd-enhancer-install-pics.21086/

 

[JetManiac]

Only somewhat tricky part is hooking up the white wires. Hookup the white wire that fits with the white wire to S/s harness first. Then remaining white wire goes to white/red of stator. (Needs a jumper to fit with 62t stator.)

 

[mike b]

Alright looks like i got everything together but i have a few black wires remaining that are all grounded to the screw next to the MSD. i have two male connectors and one female connector. SO WTF do i do here. I need another female for the party haha. and does it matter which is connected to which one. the female connector is coming from the ground on the MSD. One of the male connectors is coming from the stator plate and the other is coming from the s/S switch wires

NOTE: This is a box from a waveraider so i may have some extra wires in the box

 

[JetManiac]

Extra ground pigtails do not need to hook to anything, just need to ground each wire.

 

[mike b]

Now if i do connect one of the males and the female together will that damage anything. Should i tape these off if not connected. This box was in use earlier this year i just forget how they connect and if they were in fact connected to anything

 

[mike b]

@stingrayguy