- Location
- Minneapolis, MN
Ok folks, the 2021 TC Jetpilots Sortie raffle ski is complete. Thanks to all those who donated parts, especially JetManiac and Watcon. A reminder that all winners must be in attendance. Here is the build list:
HULL
-1990 Yamaha Superjet hull
-defoamed, refoamed with solid pink closed cell foam, additional stainless cooling tubes, full 2.5" exhaust tube
-new paint, including engine bay
-PWC Graphics . com 2017 Superjet graphics
-24/7 footholds, tray reinforced, new hydroturf and hydroturf under padding
-Watcon/RCJS billet square nose to round nose pole conversion bracket (super nice piece!)
-OEM round nose pole
-x metal steering plate
-RRP straight bars
-ODI grips (not shown)
-UMI angle pull throttle
-pre 2008 superjet steering cable (more throw)
-144mm superjet pump with solas impeller
-Protec intake grate and ride plate
ENGINE BAY
-new gaskets and seals 62T/62T engine
-62T electronics
-ported cylinders by Jason Augustine (Yamanube) with custom TCJP etching
-freshly rebuilt mikuni dual 38mm carbs with OEM dual airbox (2 screens removed)
-PFM lightened flywheel
-timing advance
-custom TCJetpilots engraved RIVA cylinder head with dress up head bolts
-coffmans sizzler pipe
-dual cooling
-Jetworks flow control valve
-silicone exhaust hoses (long and short)
-round nose SJ waterbox
-OCD solutions battery cable
-new hoses, fuel lines and filter
I can't wait to see who the lucky winner of this will be!
(more photos to come)
HULL
-1990 Yamaha Superjet hull
-defoamed, refoamed with solid pink closed cell foam, additional stainless cooling tubes, full 2.5" exhaust tube
-new paint, including engine bay
-PWC Graphics . com 2017 Superjet graphics
-24/7 footholds, tray reinforced, new hydroturf and hydroturf under padding
-Watcon/RCJS billet square nose to round nose pole conversion bracket (super nice piece!)
-OEM round nose pole
-x metal steering plate
-RRP straight bars
-ODI grips (not shown)
-UMI angle pull throttle
-pre 2008 superjet steering cable (more throw)
-144mm superjet pump with solas impeller
-Protec intake grate and ride plate
ENGINE BAY
-new gaskets and seals 62T/62T engine
-62T electronics
-ported cylinders by Jason Augustine (Yamanube) with custom TCJP etching
-freshly rebuilt mikuni dual 38mm carbs with OEM dual airbox (2 screens removed)
-PFM lightened flywheel
-timing advance
-custom TCJetpilots engraved RIVA cylinder head with dress up head bolts
-coffmans sizzler pipe
-dual cooling
-Jetworks flow control valve
-silicone exhaust hoses (long and short)
-round nose SJ waterbox
-OCD solutions battery cable
-new hoses, fuel lines and filter
I can't wait to see who the lucky winner of this will be!
(more photos to come)